top of page

CT-300

For bipolar currents up to ±300 A, the CT-300 from ELS Instruments (formerly CAEN ELS) provides isolated, high stability measurement based on 0-FLUCS fluxgate technology. It is a step into the larger housing of the range, with a 30 mm primary conductor hole that accommodates heavier cables and busbars. The transformation ratio is 1:1500, giving 200 mA at full scale. Its small signal response extends past 100 kHz, noise referred to the input is below 1.5 ppm/FS (200 Hz), and thermal drift is below 0.5 ppm/°C on current output, or 2 ppm/°C on voltage output. Supply voltage is ±15 V. Typical uses include magnet power converter regulation at accelerator facilities, EV inverter and traction motor development, and grid-connected storage research, where currents of a few hundred amps must be known accurately over long test campaigns. Choosing between current and voltage output depends on your readout chain, and both are available. ProDigitek supplies ELS current sensors to labs and industry all over Australia. Get a CT-300 quote by contacting us.

CT-300

Key specifications

Maximum DC primary current
±300 A
Current polarity
Bipolar
Transformation ratio
1:1500
Small signal bandwidth (±3 dB)
> 100 kHz
Equivalent input noise
< 1.5 ppm/FS @ 200 Hz
Temperature coefficient
< 0.5 ppm/°C (current output), < 2 ppm/°C (voltage output)
Primary conductor hole
30 mm
Supply voltage
±15 V
bottom of page