top of page

BatReg²

BatReg² is a bidirectional, regenerative range of digital supplies made by ELS Instruments (formerly CAEN ELS) built for battery testing, cycling and charging. Energy taken from the battery during discharge is returned to the grid rather than wasted as heat, cutting running costs and lab cooling loads during long cycling campaigns. Output voltage ranges from 0 to 10 V up to 0 to 100 V and output current from ±20 A to ±150 A depending on model, and either 1500 W or 2000 W of rated power. Regulation modes include CC, CV, CP and CR, so it can reproduce realistic drive cycles and power profiles. Built-in electrochemical impedance spectroscopy covers 10 mHz to 2 kHz, providing state of health insight without a separate analyser. Setting and readback resolution is 24 bit and output accuracy is better than 0.01 % of full scale. Communication runs over Gigabit Ethernet with two fast SFP+ links. It suits cell and module testing, EV and stationary storage research, and second-life battery assessment. Contact ProDigitek to discuss BatReg² for your battery lab.

BatReg²

Key specifications

Output voltage range
0 to 10 V up to 0 to 100 V (model dependent)
Output current range
±20 A to ±150 A (model dependent)
Rated output power
1500 W or 2000 W
Regulation modes
CC, CV, CP and CR
EIS frequency range
10 mHz to 2 kHz
Setting/readback resolution
24 bit
Output accuracy
< 0.01 %/FS
Communication
Ethernet 10/100/1000 Mbit, 2 x fast SFP+
bottom of page